Jerry wanted to see some pictures of the Quickie exhaust system.  So...

Click on the image to expand, then use your browser's "Back" button to return to this page

N5391M Page

Here is the new RevMaster stainless exhaust.  Joe is trying to get the correct fit to work with the tri-gear conversion.

After I removed the Diehl nose gear bracket, things line up very nicely.

Joe reworked the Diehl nose wheel mount and shipped it to me to review.  There just wasn't any clearance between the exhaust and the structural tubes of the engine and nose wheel mount.  I sent it back to Joe

I spoke with Steve Bennett at Oshkosh.  He sent me an exhaust made from mild steel.  It bolts right in but doesn't have much clearance either.  Dan Diehl recommended wrapping the cross-over tubes with heat insulating tape.